31
DRAIN REQUIREMENTS
1. Drain capable of eliminating 17 gallons (64.3 L) per
minute.
2. A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.
3. The standpipe height above the floor should be:
Minimum height: 33 in. (83.82 cm)
Maximum height: 96 in. (244 cm)
NOTE:
For installations requiring a longer drain hose,
have a qualified technician install a longer
drain hose, P/N 131461201, available from
an authorized parts distributor. For drain
systems in the floor, install a syphon break
kit, available from your local hardware store.
ROUGH-IN DIMENSIONS
↓
↓
↑
↑
96" Max.
(244 cm)
33" Min.
(83.82 cm)
LID OPEN 90°
FRONT VIEW
SIDE VIEW
DRAIN
OUTLET
DRAIN
OUTLET
(REAR)
WATER
INLETS
(REAR)
27"
27"
3-3/4"
(129.54
cm
)
(9.53 cm)
(68.58 cm)
(68.58 cm)
(74.77 cm)
29-7/16" (111.76
cm)
44"
51"
(29.05 cm)
←
11-7/16"
LOCATION OF YOUR WASHER
DO NOT INSTALL YOUR WASHER:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60 degrees F (15.6
degrees C) for proper washer operation.
2. In an area where it will come in contact with curtains
or drapes.
3.
In an area (garage or garage-type building) where
gasoline of other flammables are kept or stored
(including automobiles).
4. On carpet. Floor
MUST BE SOLID
with a maximum
slope of 1 in. (2.54 cm). To ensure vibration or
movement does not occur,
REINFORCEMENT
of the
floor may be necessary.
IMPORTANT MINIMUM INSTALLATION
CLEARANCES
When installed in alcove: Sides = 0" (0 cm),
Rear = 0" (0 cm), Top = 20" (50.8 cm).
When installed in closet: Sides = 0" (0 cm),
Rear = 0" (0 cm), Top = 20" (50.8 cm), Front = 1"
(2.54 cm).
Closet door ventilation required: 2 louvered openings
each 60 square inches (387 cm
2
) 3 inches (7.6 cm)
from bottom and top of door.
UNPACKING
1. Using the four shipping carton corner posts (two
on each side), carefully lay the washer on its left
side and remove foam shipping base.
2. Using a ratchet with 3/8" socket, remove the
mechanism shipping bolt and plastic spacer block
from the center of the base.
NOTE:
If the washer is to be transported at a later
date, the tub blocking pad, shipping bolt,
and plastic spacer block should be
retained.
MECHANISM
SHIPPING
BOLT
PLASTIC
SPACER
BLOCK
SHIPPING BLOCKS
DRAIN HOSE
POWER
CORD
FOAM
SHIPPING
PAD
SHIPPING CARTON
CORNER POSTS
Summary of Contents for 2.7 Cu. Ft. Tubs
Page 10: ...10 Caution Disconnect Electrical Current Before Servicing ...
Page 11: ...11 ...
Page 35: ...35 ...
Page 80: ...80 ...
