Electrolux 236200, Installation And Operation Instructions Manual

 47

5958 962 00

GB

5954 00U 01

 4.3.6 CORE PROBE USE     

(PRODUCT CORE TEMPERATURE CONTROL)

The core probe allows accurate control of the core temperature 

of the product being cooked. This enables setting of the required 

value (from 10°C to 99°C) and automatic stopping of cooking 

when that value is reached.

Attention: 

The core probe is a precision component. 

Absolutely avoid impacts, forcing when inserting, and 

pulling of the 

fl

 exible cable (in particular when using 

the trolley-mounted structures). The warranty does 

not cover the replacement of core probes damaged by impro-

per use.

After selecting the time icon select that of the core probe and 

press 

START

 to start the cycle.

- Wait until the compartment temperature 

fi

 eld indicates reaching 

of preheating (the message LOAD appears).

- Open the door and introduce the product to be cooked.

Attention! 

Risk of burns.

Always

 open the door with caution when the oven 

is hot.

1) Remove the core probe "A" from its seat "B" and insert it in 

the product without forcing excessively, making sure the tip (the 

sensitive part) is positioned near the centre of the product.

A

B

      1-sensor core probe

- Close the door and press the 

START button.

2) 

Stopping the cycle

. When the required product core tempe-

rature is reached the oven stops automatically and the elapsed 

cooking cycle time is displayed.

3) 

Core probe mode deactivation

. Set a cooking time on the 

Timer

. 

This action automatically cuts out the core probe, 

whereas it is the opposite when the time is set.

The core probe mode is also deactivated when the oven is 

switched off.

Note:

With vacuum packed food products it is necessary to use the 

special external core probe (accessory available on request), to 

be connected to the USB socket.  For its use, see the instructions 

included with the accessory. 

 4.3.7 END OF COOKING 

At the end of the set time, the cooking cycle automatically stops 

and the oven buzzer sounds continuously.

The display shows the message:
 



  COOKING 

FINISHED 

!

Several parameters such as the following are also displayed:

- total time

Open the door and remove the product.

Attention! 

Risk of burns.

Always

 open the door with caution when the oven 

is hot.

Notes

:

- The buzzer can be stopped in advance by carrying out any 

operation on the control panel or by opening the door.

The cooking cycled can be manually stopped by keeping

the STOP button pressed for a few seconds.

A cycle identical to that just completed can be repeated by

pressing the START button again. 
The maintaining (HOLD) cycle can be done.