124
Storage drawer panel:
1. The drawer panel is held to the drawer body by bolts
and nuts, two on each side. To remove the panel
remove the four nuts and bolts.
Drawer panel nuts and bolts
Storage drawer rollers:
1. There are four rollers, two on the drawer and two on
the rails, that the drawer glides on.
2. These rollers are riveted on. The replacement roller
will come as a kit with a roller, a shoulder bolt, and a
nut. To replace the roller, drill out the rivet and use
the kit.
Riveted rollers
Storage drawer rails:
1. The storage drawer rails are held to the front frame
by one screw and supported in the rear by an opening
in the rear panel.
Storage drawer rails
Front panels:
1. The front panels are held in place by two screws
from the front and one behind the control panel.
2. Remove the two screws from the front,one at the
bottom and one at the top, holding the panel to the
front frame.
One at the top and one at the bottom
3. Remove one screw behind the control panel and lift
the panel off.
One screw behind the control panel
Summary of Contents for 30" GAS FREESTANDING RANGES
