125
3. Remove the two screws holding the igniter to the
bake burner and lift the igniter off.
Igniter mounting screws
Bake burner:
1. Disconnect power, remove the burner baffle and the
screws holding the igniter to the burner.
2. Remove one screw at the rear holding the burner to
the burner pan and one screw at the front holding
the burner to the front frame.
Front screw
Rear screw
Bake burner pan:
1. Remove the baffel, bake burner, four screws on each
and two screws in the front and rear holding the pan
to the oven bottom frame.
Oven bottom:
1. The oven bottom is held in place by two tabs at the
rear and a flange in the front. To remove the oven
bottom, pull forward on the oven bottom until the
tabs have cleared the brace.
Flange
Tabs
Oven burner baffle:
1. Remove the oven bottom, the two screws holding
the baffel to the front frame and slide the baffle forward.
Burner baffle screws
Bake burner igniter:
1. Disconnect power, remove the burner baffle and the
oven safety valve cover.
2. Disconnect the igniter wires from the safety valve
and harness.
Igniter wires
Summary of Contents for 30" GAS FREESTANDING RANGES
