22
Figure 5
Figure 6
2. Convert Surface Burners for use with LP/
Propane Gas
Unlike the standard gas range,
THIS
COOKTOP IS NOT REMOVABLE
. Do not attempt to
remove this cooktop. Save the natural gas orifices
removed from the appliance for possible future conversions
to natural gas.
For all burner locations:
a. Remove the top grate and burner cap (See Figure 6).
b. Use your hand to remove the burner head.
c. Remove the four factory installed natural gas orifices
from the center
of the orifice holders using a 7
mm nutdriver (See Figure 7). Remember to keep the
original Natural Gas Orifices for later conversion to
Natural Gas. Refer to page 1 under "IMPORTANT" to
identify their markings.
d. Replace the orifice in each of the four orifice holders
with the correct LP/Propane gas orifice
(refer to the
LP Kit chart listed on page 1; also refer to Figures
4 and 5 for the correct LP orifice installation at
each of the four surface burner locations)
. Tighten
each orifice until snug. Use caution not to overtighten.
e. Replace the four burner heads (be sure burner head
mates correctly with each surface igniter) then replace
the burner caps and grates.
Use caution when replacing each burner
cap so the electrode is not damaged.
Figure 7
Summary of Contents for 30" GAS FREESTANDING RANGES
