16
If the door is opened during this stage the message
"CLOSE" will scroll on the display:
The filling and heating stage has finished when the
display shows the tank temperature:
To display the boiler temperature during heating of the
tank, open the door and press “J” button (Figure 12).
Supplied racks
•
Tray rack: PW1M/WT830M/PW1MH/WT830MH =
1 piece; PW2M/WT850M = 2 pieces.
•
Basket for pots and pans.
D2
WASH CYCLES
The wash cycle includes one wash with hot water and
detergent (158°F/70°C min.) and one rinse with hot
water and rinse-aid (183°F/84°C min.).
Table of times
Standard cycle time with supply water at 122°F/50°C.
A device lengthens the cycle time if the water in the boi-
ler has not reached the minimum temperature for correct
rinsing.
The cycle times and the temperature may be personali-
sed (e.g. increase of the rinse time and temperature).
The cycle times should only be set by an Authorized
Service technician.
D3
OPERATION
The filling and heating stage has finished when the dis-
play shows the tank temperature:
The appliance is then ready for use:
•
Open the door.
•
Pour the required amount of detergent into the tank.
•
Insert the dirty pots and pans upside down on the
basket (Figure 13/ Figure 14).
•
Tie pots and pans with supplied rubber bands “S” as
showed in Figure 13/ Figure 14.
CAUTION:
Do not stack pots and pans one on top of
another as water must have free access to all sides of
every pot or pan. Leave a minimum gap of 4" / 101 mm
between pans and the edge of the rack (Figure 13/
Figure 14).
Figure 13
Figure 14
I
II
III
IV
PW1M/WT830M
PW1MH/WT830MH
PW2M/WT850M
360 sec
360 sec
360 sec
600 sec
600 sec
600 sec
900 sec
900 sec
900 sec
INFINITE
INFINITE
INFINITE
1
4”
101 mm
4”
101 mm
4”
101 mm
4”
101 mm
S
4”
101 mm
4”
101 mm
4”
101 mm
4”
101 mm
S
