ENGLI
S
H
15
D2
Handling
Arrange a suitable area with flat floor for machine
unloading and storage operations.
D2.1
Procedures for handling operations
For correct and safe lifting operations:
•
use the type of equipment most suitable for charac-
teristics and capacity (e.g. lift trucks or electric pallet
truck);
•
cover sharp edges;
•
check the forks and lifting procedures according to
the instructions given on the packing.
Before lifting:
•
send all operators to a safe position and prevent per-
sons from accessing the handling zone;
•
make sure the load is stable;
•
make sure no material can fall during lifting, and
manoeuvre vertically in order to avoid impacts;
•
handle the machine, keeping it at minimum height
from the ground.
D2.2
Translation
The operator must:
•
have a general view of the path to be followed;
•
stop the manoeuvre in case of hazardous situations.
D2.3
Placing the load
Before placing the load make sure the path is free and
that the floor is flat and can take the load.
D3
Storage
The machine and/or its parts must be stored and pro-
tected against damp, in a non-aggressive place free
of vibrations and with room temperature of between -
10°C / 14°F and 50°C / 122°F.
The place where the machine is stored must have a flat
support surface in order to avoid any twisting of the
machine or damage to the support feet.
CAUTION!
For machine lifting, do not use movable
or weak parts such as casings, electrical
raceways, pneumatic parts, etc., as
anchoring points.
IMPORTANT!
During the storage phase the machine
can be stacked on another as shown in
the pictogram on the packing.
IMPORTANT!
Machine positioning, installation and
disassembly must be carried out by a
specialized technician.
IMPORTANT!
Do not make modifications to the parts
supplied with the machine. Any missing
or faulty parts must be replaced with
original parts.
