g
62
Operating multifunction section
0
Open cover (fig. 1/F) and place all
ingredients required in the all-purpose
bowl.
Caution:
Do not exceed maximum fill-
ing volume:
– liquid 1.75 litres
– solid 1.5 litres
3
Further ingredients can be added dur-
ing operation through the filling inlet.
The filling beaker in the stopper (fig.
1/E) can also be used for this purpose.
Close the filling inlet immediately each
time to avoid splashes.
1
Use the stopper exclusively to com-
press the cutting items!
0
Start the appliance: turn speed selector
(fig. 1/l) right to the desired speed set-
ting or press the pulse button (fig. 1/J).
3
It is recommended to start at a slow
speed and then to increase the speed.
The appliance operates at maximum
speed by pressing the pulse button.
Refer to the section "Tips on using
multifunction section" for reference
values.
1
If the warning lamp (fig. 4/a) flashes
and the appliance cannot be started,
the safety cover for the mixer drive
(figs. 1/S and 4) is not properly fitted.
0
Switch off appliance: turn speed selec-
tor left to the "0" position.
0
After using, turn cover
clockwise
and
remove.
1
Only remove the cover when the tool
has come to a complete stop!
0
Remove the tool and spindle.
0
Turn the all-purpose bowl
clockwise
and remove.
Citrus press
(Food Processor 750 only)
Preparation (fig. 13)
0
Fit all-purpose bowl as described above
(fig. 5).
0
Place sieve insert of citrus press (fig.
13/a) on all-purpose bowl (arrow
on arrow
) and turn
cunter-clock-
wise
to the stop. The sieve insert can
be heard to engage, arrow
must
coincide with arrow
.
0
Insert press cone (fig. 13/b) in sieve
insert.
Operating citrus press
0
Start appliance: turn speed selector
(fig. 1/J) right to position 1.
3
The citrus press must only be operated
at the lowest speed.
0
Switch off appliance: turn speed selec-
tor left to the "0" position.
0
Remove press cone after use.
0
Turn sieve insert
clockwise
and remove.
0
Turn all-purpose bowl
clockwise
and
remove.
1
The appliance can be used for up to
10 minutes without stopping. It should
be allowed to cool each time following
prolonged, continuous operation (for
at least 20 minutes after using for
10 minutes without stopping).
Cleaning and care
Motor casing
1
Ensure that no liquid enters the motor
casing!
0
Clean the motor casing with a moist
cloth.
Never immerse in water or hold
under running water
!
Summary of Contents for 7 Series
Page 2: ...2 A B C D E F H J I M K N O P Q R S L G T 1 ...
Page 3: ...3 a 3 2 5 4 7 6 ...
Page 4: ...4 11 10 9 8 ...
Page 5: ...5 a b a b 12 13 14 15 ...
