13
the
Unit of Measure Indicator light
starts flashing.
- To change the SET temperature, press
SET/DOWN
button or
MANUAL DEFROST/UP
button within 15 seconds
SET
or
- To store the new set value, wait until it stops flashing to exit
the program
SET
if a selection is not made after 15 seconds, the last value dis-
played will be confirmed automatically and the chamber tem-
perature display is restored.
Example of setting:
- switch on the appliance
B.2.7 CHECKING HINGES
Have the hinges of the appliance checked every two years by a
technician. If necessary, adjust and grease the hinges.
C.1.1 CONTROL PANEL
2
3
4
1
CATEGORY
HUM
HIGH
%
SET
HACCP
ACCESS TO
FOOD CATEGORIES
HIGH HUM.
ON/OFF
SERVICE
ALARMS
TEMPERATURE/
CATEGORY
SELECTION
MANUAL
DEFROST
COMPRESSOR
STATUS
POWER SUPPLY
STATUS
HACCP
ALARMS
7 DAYS
REPORT
POWER ON/OFF
1 -
Access to Food Categories button
2 -
High humidity ON/OFF button
2a -
High humidity indicator light
3 -
Service alarms button
3a -
Service alarms indicator light
4 -
Manual defrost / UP button
5 -
Set temperature / Category selection / DOWN button
6 -
HACCP alarms button
7 -
Display
8 -
Compressor status indicator light
9 -
Power supply status indicator light
10 -
Power ON/OFF button
C.1.2 INITIAL SWITCH-ON AND TEMPERATURE ADJUSTMENT
The appliance features an
ON/OFF
switch for activating the
appliance.
Turn on the appliance by pressing the
ON/OFF
button:
To set the chamber temperature, follow these steps:
- press and hold
SET/DOWN
button for 5 seconds,
SET
the
SET POINT
value appears on the display
C.1 OPERATIONS and USER
INSTRUCTIONS
1
2a 3a 4
7
8
9
2
3
5
6
10
