33
Temperature setting buttons
The temperature is adjusted using the „B“ and „D“ buttons. These buttons
are connected to the temperature display.
• The temperature display is switched over from the display of the ACTUAL
temperature (Temperature display is illuminated) to the display of the
DESIRED temperature (Temperature display flashes) by pressing one of the
two buttons, „C“ or „E“.
• Each time one of the two buttons is pressed again the DESIRED
temperature is adjusted by 1 °C. The DESIRED temperature must be
reached within 24 hours.
If neither button is pressed, the temperature display automatically switches
back after a short period (approx. 5 sec.) to the display of the ACTUAL
temperature.
DESIRED temperature means:
The temperature that has been selected for inside the freezer. The DESIRED
temperature is indicated by flashing numbers.
ACTUAL temperature means:
The temperature display indicates the current temperature inside the freezer.
The ACTUAL temperature is indicated with illuminated numbers.
Select "Freezing" or "Cooling"
If necessary, switch over the appliance with the following steps between the
operating modes "Freezing" and "Cooling":
1.
Hold down the SUPER button and the „+“ (WARMER) button simultaneously
for 5 seconds.
• When the setting is switched from “Freezing” to “Cooling” “FC” (Freezing -
Cooling) appears in the temperature display, an acoustic signal confirms the
change and the temperature display changes to flashing figures (DESIRED
temperature cooling mode +5 °C). Using the temperature setting buttons, the
required temperature for the cooling mode can now be entered.
• When the setting is switched from “Cooling” to “Freezing” “CF” (Cooling
- Freezing) appears in the temperature display, an acoustic signal confirms the
change and the temperature display changes to flashing figures (DESIRED
temperature freezing mode -18 °C). Using the temperature setting buttons,
the required temperature for the freezing mode can now be entered.
The operation mode, in which your appliance is at the moment, is identifiable
if the temperatures can be set above or below 0 °C.
2.
Set the temperature depending upon the selected operation mode (see
the chapter "Temperature Adjustment").
36
Switching the Appliance off
To switch off, hold down the ON/OFF button for approx. 3 seconds. This will
result in a countdown from "3" to "1" taking place in the temperature
display. On reaching "1" the fridge will switch off. The temperature display
will go off.
Note:
The appliance cannot be switched on or off if unplugged, or if there
is no power being supplied to it. Following connection to the mains power
supply, the appliance returns to the same operating state as before the
interruption of main power.
If the appliance is not going to be used for an extended period:
1.
Switch off the appliance, holding down the ON/OFF button until the display
goes off (see above).
2.
Remove the mains plug or switch off or turn out the circuit breaker or fuse.
3.
Defrost the freezer compartment and clean the appliance thoroughly (see
section: “Cleaning and Maintenance”).
4.
Finally, leave the doors open so as to avoid a build up of odours
