10
If you are still unable to solve the problem, summon the assistance of authorised service staff. Do not take any other steps. Incorrect
procedure may cause personal injury or lead to additional defects. It is quite normal for the freezer to seem warm on the outside occa-
sionally, owing to the heat generated by the freezing process. This heat also helps to prevent the formation of moisture on the outside
of the appliance which could cause rust. If the freezer has been switched off briefly, the compressor may not start immediately when
the current is re-connected. This is quite normal.
HOW TO CHANGE THE BULB
Before changing the bulb, isolate the appliance from the electricity supply. Exert pressure to remove
the light glass as shown in the drawing. Unscrew the bulb, and replace it with a new bulb (max. 15W).
Then re-connect the electricity supply. Extra bulbs are available from your local Electrolux Service
Centre.
PREPARATION OF ICE CUBE MAKER
1.Fill the ice cube maker until the cubes will be full in the horizontal position or by the
load line mark in the vertical position. After this close the ice cube maker with cap.
2.Place the holder in the lid of the freezer and leave to solidify
3.To loosen the frozen cubes, either bend the ice cube tray or hold it under running
water for a few seconds.
Important
! Never try to free an ice tray that is frozen to the freezer compartment
using pointed or sharp edged objects. Use a soft plastic scraper.
ACCESSORIES
Spare baskets can be obtained from your local Service Centre. The
illustrations on this page show how many baskets can be placed in the
various freezer models.Measure the length of your freezer and find the
appropriate illustration. The number above each illustration indicates its
length in millimetres.
Defect:
Freezer not
cold enough
Freezer too
cold
Too much
frost
formed
Check if:
Green light not on
Green and red light on
Green light on, red
light not on
Yellow light on
Yellow light not on
Lid does not close
completely
Lot of moisture in the
room
Goods packed poorly
Possible cause:
Plug not connected correctly
Defect in switch or fuse
Power failure
Fresh food recently placed in freezer
Lid open too long
Thermostat set too warm
Lot of frost and ice formed
“Super” function active
Thermostat set too cold
Lid in contact with goods in free-
zer
Moisture from washing machine,
tumble-dryer, etc.
Lot of moisture from goods
Action:
Check plug and socket
Check fuse, call electrician
Wait until current returns
Wait a couple of hours
Wait a couple of hours
Set thermostat colder
Defrost freezer
Press “Super” button out
Set thermostat warmer
Re-arrange goods, check that lid
closes correctly
Move freezer to a room with less
moisture, or air regularly
Re-pack goods, see under
“How to use”
IF YOUR FREEZER DOES NOT FUNCTION SATISFACTORILY
Check the following before calling for service staff:
G
GB
B
Load line
Load line of the ice cube maker
Cup of the ice cube maker
WHEN NOT IN USE
Disconnect the appliance from the electricity supply. Remove all goods from the freezer. Clean the freezer as described above. Leave
the lid slightly open. If you are still unable to solve the problem, summon the assistance of authorised service staff. Do not take any
other steps. Incorrect procedure may cause personal injury or lead to additional defects. It is quite normal for the freezer to seem warm
on the outside occasionally, owing to the heat generated by the freezing process. This heat also helps to prevent the formation of mois-
ture on the outside of the appliance which could cause rust. If the freezer has been switched off briefly, the compressor may not start
immediately when the current is re-connected. This is quite normal.
