Once you are happy with the layout of your pipework, the joints between
the pipe and fittings (t-pieces, sweep 90° bends, couplers etc) need to be
sealed.
The pot of glue that will be included in the starter inlet kit is similar to a
nail varnish bottle - the lid comes off with a round sponge attached (rather
than a brush).
!
Get rid of any excess glue from the sponge
!
Swipe the sponge around the tip of the PIPE to be inserted into a fitting.
!
Immediately push the pipe into the fitting until it reaches the stop-
ridge inside the fitting
!
Start the next joint as soon as you want
!
The 120ml pot of glue should last for about seven inlet kit’s worth of
fittings before you would need to contact us to purchase another pot.
I
F
YOU
PUT
THE
GLUE
INSIDE
THE
FITTING
AND
THEN
PUSHED
THE
PIPE
INTO
THE
FITTING
-
GLUE
WILL
BE
PUSHED
OUT
WHERE
IT
WILL
HARDEN
INTO
AN
OBSTRUCTION
INSIDE
THE
PIPEWORK
AND
COULD
THEREFORE
CAUSE
A
BLOCKAGE. P
LEASE
FIRST
SWIPE
THE
GLUE
ON
THE
PIPE
AND
NOT
THE
F
ITTING
!
RULE 3
GLUE -
SEALING
THE
JOINTS
13
Pipe
Glue Sponge
Stop-ridge of Fitting
