Page 44
WARMER DRAWER COMPONENT SERVICE
Removing and Replacing Warmer Drawer
To Remove the Warming Drawer:
1. Turn power off before removing the Warmer Drawer.
2. Open the drawer to the fully opened position (Photo C)
3. Remove the retaining screw in the right glide release
lever.
4. Pull up on the left glide lever and push down on the
right glide lever.
5. Pull the drawer away from the range.
Photo C
Screw
Lever
To Replace the Warming Drawer:
1. Pull the bearing glides to the front of the chassis
glide (See Photo D).
2. Align the glide on each side of the drawer with the glide
slots on the range.
3. Push the drawer into the range until levers “click”
(approximately 2”). Pull the drawer open again to seat
bearing glides into position. If you do not hear the levers
“click” or the bearing glides do not feel seated remove the
drawer and repeat steps 1-3. This will minimize possible
damage to the bearing glides.
4. Reinstall the retaining screw in the right glide lever
Photo D
Bearing Glide
WARMER DRAWER THEORy OF OPERATION
Warmer drawer operation is controlled by the EOC and Oven Relay board. When the warmer drawer
is first activated a thermal disk mounted in the drawer cavity is used to detect when the warmer
drawer is cold and a call for heat is needed.
WD Settings
150°F
160°F
170°F (default)
180°F
190°F
Relay Timing
10 sec ON
50 sec OFF
15 sec ON
45 sec OFF
20 sec ON
40 sec OFF
25 sec ON
35 sec OFF
30 sec ON
30 sec OFF
If the thermal disk is initially closed, the EOC assumes that the warmer drawer is cold. In this case the
Warmer Drawer relay activates and the heating element provides continuous heat (100% time ON)
until the thermal disk opens.
After the thermal disk opens the control starts cycling the warmer drawer relay based on timing data
that is programmed into the EOC. The cycle timings correspond to the warmer drawer settings and
are typically as follows:
The thermal disk status is monitored during all the time while the Warmer Drawer is active. If the
status changes to “closed”, the relay activates again and the heating element provides continuous
heat until the thermal disk opens.
Summary of Contents for CEI30EF5GB
