Problem
Possible cause
Solution
The door is not closed
correctly.
Refer to "Closing the door".
The "FastFreeze func‐
tion" is switched on.
Refer to "FastFreeze func‐
tion".
There is too much frost
and ice.
The door is not closed
correctly or the gasket is
deformed/dirty.
Refer to "Closing the door".
Temperature is set incor‐
rectly.
Refer to "Operation" .
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
This is normal, no error
has occurred.
The compressor starts after
a period of time.
Temperature cannot be
set.
The "FastFreeze func‐
tion" is switched on.
Switch off "FastFreeze func‐
tion" manually, or wait until
the function resets automati‐
cally to set the temperature.
Refer to "FastFreeze func‐
tion".
DEMO appears on the dis‐
play.
The appliance is in dem‐
onstration mode.
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
The temperature in the ap‐
pliance is too low/too high.
The temperature regula‐
tor is not set correctly.
Set a higher/lower tempera‐
ture.
The food products' tem‐
perature is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
The thickness of the frost
is greater than 4-5 mm.
Defrost the appliance.
The door has been
opened often.
Open the door only if neces‐
sary.
The "FastFreeze func‐
tion" is switched on.
Refer to "FastFreeze func‐
tion".
There is no cold air circu‐
lation in the appliance.
Make sure that there is cold
air circulation in the appli‐
ance.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
8.2 Closing the door
1. Clean the door gaskets.
www.electrolux.com
12
Summary of Contents for CI8001
Page 63: ...ESPAÑOL 63 ...
