Installation manual
25
5.1
Network Functions
Note!
Can only be used on premium products.
This product can be connected to ELS VISION or to an external payment system.
fig.W01529
Connecting to ELS Vision
Connect the network cables GND, RX, TX, 24V to the terminal block as illustrated.
Connect the neutral position switch to terminal block positions 1 and 2, as illustrated.
Activate the connection to ELS Vision as follows:
Press and hold the Stop button, and then press both program buttons.
ACCESS 0000 is shown in the display.
Enter the code 9191.
Enter the numbers using the program buttons; press Stop.
Use the program buttons to move to Parameter 117, and enter the parameter using the Stop button.
Select the baud rate that matches the setting in ELS Vision:
0: off, 1: 2400 bps, 2: 4800 bps, 3: 9600 bps.
Use the Stop button to exit the parameter.
Then access parameter 118 and set network address 1–127.
To confirm the new settings: Press the Stop button and then Butterfly.
Connecting to an external payment system
Connect the cables from the external payment system to terminal block positions 1 and 2 "EXT SW".
Activate the connection to the external payment system as follows:
Press and hold the Stop button, and then press both program buttons.
ACCESS 0000 is shown in the display.
Enter the code 9191.
Enter the numbers using the program buttons; press Stop.
Summary of Contents for DC6-14HP
