SOI/TD 2005-2 PR
19/26
599 36 83-66
10 USER MODE
With this procedure it is possible to:
•
Modify the regeneration level selection (depending on the water hardness)
•
Activate or deactivate the buzzer signalling.
10.1 Regeneration selection
1. Press
button
S0
to switch on the dishwasher.
cancel any selected cycles pressing button
S2
for at least 3sec.
the End of cycle LED flashes.
if featured, the Salt/Rinse aid LED light up.
2. Press and hold down button
S2
(the relative LED lights up) until:
LED
L2
starts flashing.
LED
L3
ligths up steadily.
Salt/Rinse aid LEDs (if featured) switches off.
3. Wait till LED
L3
switches off.
The regeneration level is displayed by the
End of cycle
LED which flashes and pauses at intervals.
4. Press
button
S2
to increase the regeneration level according to the following values:
No. of flashes of
“End of cycle” LED
Water fill between
regeneration
procedures
Time
regeneration
solenoid opens
Position of
tank
selector
Hardness of water
treated
Level
nº
Litres
sec
nº
º F (TH) º D (dH)
1
1
- - -
0
1
0 > 7
0 > 4
2
2
130
240
1
8 > 18
4 > 10
3
3
94
240
1
19 > 25 11 > 14
4
4
70
240
1
26 > 32 15 > 18
* 5
5
53
240
2
33 > 39 19 > 22
6
6
37
240
2
40 > 50 23 > 28
7
7
20
240
2
51 > 64 29 > 36
8
8
15
240
2
65 > 75 37 > 42
9
9
10
240
2
76 > 90 43 > 50
10
10
3
2x240
2
91 > 125 51 > 70
* “5” =
Level set by factory Position of tank
selector:
“2”
10.2 Buzzer
The buzzer is a device which generates acoustic signals to indicate the
End of cycle
and eventually
an
Alarm
situation. These signals can be excluded through a button combination:
1. Press
button
S0
to switch the appliance on.
cancel any selected cycles pressing button
S2
for at least 3sec.
the End of cycle LED flashes.
if featured, the Salt/Rinse aid LEDs light up.
2. Press and hold down button
S2
(the relative LED lights up) until:
LED
L2
starts flashing.
LED
L3
lights up steadily.
Salt/Rinse aid LED (if featured) switch off.
3. Press
button
S2
, before LED
L3
switches off.
LED
L2
lights up.
LED
L3
flashes.
4. Wait till LED
L2
switches off.
the End of cycle LED indicates if the function is activated or not.
5. Press
button
S2.
the End of cycle LED indicates the new function state.
