Electrolux E44, Use & Care Manual

Using the Rotisserie & Side Burners

15

ROTISSERIE  LIGHTING

Open the lid. Push and turn the control knob for the
rotisserie counter clockwise to the “HIGH” position. 

Wait

5 seconds

. Then press and hold the electronic igniter

button. You’ll hear a snapping sound. If the burner
does not light in 4 seconds, turn the control knob to
OFF and wait 5 minutes before trying again. Once lit,
turn the control knob to the desired setting. (See Fig.
18)

MATCH LIGHTING

If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Attach the
match to the match extender, located inside the right
cart door.

Keep your face as far away from the grill surface as possi-
ble and hold a match, attached to the match extender, to
the burner

, then 

push and turn the control knob counter

clockwise to the “HIGH” position. (See Fig. 19)

NOTE: After the first use the stainless steel around
the burner will darken. This is a normal reaction of
premium stainless steel to heat and is not a defect.
The infrared panel will also darken after initial use.
This is also a normal occurrence.

SIDE BURNER LIGHTING

Push and turn the control knob to the “HIGH” position
and immediately press and hold the electronic igniter
button. You’ll hear a snapping sound. It may be nec-
essary to hold the electronic starter button for about 4
seconds. If the burner does not light in 4 seconds,
turn the knob to the “OFF” position and wait 5 minutes
before trying again.  Repeat above steps to light
remaining burners. (See Fig. 20)

MATCH LIGHTING OF THE BURNER

If by chance the electronic igniter does not light the
burner, the burner may be lit with a match. Keep your
face as far away from the burner as possible and
place a lit, long stem match through the spaces in the
grate to the ports of the burner. Position the match
near the burner ports and push and turn the control
knob to the “HIGH” position.  

Fig. 18

Fig. 19

Fig. 20

NOTE: Do Not operate the main
burners and infrared back burner
at the  same time. This can cause
warping of the roll top grill hood.

!