38
4
8.
For washing machine. Adjust the
appliance adjustable feet at a
suitable height to allow it to slide
under the foot locking brackets.
9.
For washing machine. Lay the
pedestal on the same side and
slide it forward so that the
appliance front feet slides under
foot locking brackets.
11.
For washing machine. Put the
pedestal and appliance in vertical
position. If necessary, adjust the
appliance feet and go to step 16.
Check that the screws are firmly
screwed.
12.
For tumble dryer. Unscrew and
retain the two bottom screws from
the back of the appliance.
10.
For washing machine. Use the
screws supplied to secure the rear
brackets (B) on both the washer
and the pedestal.
13.
For tumble dryer. Screw the rear
brackets (C) on the pedestal by
using the screws supplied in the
stand box.
Võtke alus ja kõik tarvikud
kastist välja.
Veenduge, et aluse külge on kinnita-
tud kummist jalad.
Reguleerige eesmisi jalgu nii, et alus
seisaks stabiilselt.
Kui paigaldate aluse täiesti uue sead-
me alla, võtke see vastavalt olema-
solevatele juhistele pakendist välja ja
jätkake seejärel 6. sammuga.
Kui seade on juba ühendatud:
- Ühendage toitepistik pistikupesast
lahti.
- Sulgege veekraan.
-ühendage sisselaskevoolik(ud)
veekraani küljest lahti ja laske veel nii
sellest (nendest) kui ka tühjendusvoo-
likust välja voolata, suunates veejoa
madalasse nõusse.
Paigalduse protseduur
3
Installation Procedure
1.
Remove the pedestal and all
accessories form the box.
2.
Make sure that the rear rubber
feet are mounted.
3.
Adjust the front adjustable feet to
make the pedestal stable.
4.
If you install the pedestal under a
brand new appliance, unpack the
appliance as indicated in the
instructions supplied with it and
then proceed with step 6.
5.
If the appliance is already
connected:
- Disconnect the mains plug from
the mains socket.
- For washing machine. Close the
water tap.
- For washing machine.
Disconnect the inlet hose(s) from
the water tap and let the water
flow out from the inlet hose(s)
and the drain hose and collect it
in a shallow basin.
- For tumble dryer. Empty the
water container in a wash basin
or, if available, activate the direct
drain system to let the water flow
out.
6.
Screw the front brackets on the
pedestal.
7.
For washing machine. Gently lay
the washing machine on its
detergent dispenser side.
Lay it on cardboard or on a piece
of polystyrene to avoid scratching
the cabinet.
3
Installation Procedure
1.
Remove the pedestal and all
accessories form the box.
2.
Make sure that the rear rubber
feet are mounted.
3.
Adjust the front adjustable feet to
make the pedestal stable.
4.
If you install the pedestal under a
brand new appliance, unpack the
appliance as indicated in the
instructions supplied with it and
then proceed with step 6.
5.
If the appliance is already
connected:
- Disconnect the mains plug from
the mains socket.
- For washing machine. Close the
water tap.
- For washing machine.
Disconnect the inlet hose(s) from
the water tap and let the water
flow out from the inlet hose(s)
and the drain hose and collect it
in a shallow basin.
- For tumble dryer. Empty the
water container in a wash basin
or, if available, activate the direct
drain system to let the water flow
out.
6.
Screw the front brackets on the
pedestal.
7.
For washing machine. Gently lay
the washing machine on its
detergent dispenser side.
Lay it on cardboard or on a piece
of polystyrene to avoid scratching
the cabinet.
3
Installation Procedure
1.
Remove the pedestal and all
accessories form the box.
2.
Make sure that the rear rubber
feet are mounted.
3.
Adjust the front adjustable feet to
make the pedestal stable.
4.
If you install the pedestal under a
brand new appliance, unpack the
appliance as indicated in the
instructions supplied with it and
then proceed with step 6.
5.
If the appliance is already
connected:
- Disconnect the mains plug from
the mains socket.
- For washing machine. Close the
water tap.
- For washing machine.
Disconnect the inlet hose(s) from
the water tap and let the water
flow out from the inlet hose(s)
and the drain hose and collect it
in a shallow basin.
- For tumble dryer. Empty the
water container in a wash basin
or, if available, activate the direct
drain system to let the water flow
out.
6.
Screw the front brackets on the
pedestal.
7.
For washing machine. Gently lay
the washing machine on its
detergent dispenser side.
Lay it on cardboard or on a piece
of polystyrene to avoid scratching
the cabinet.
3
Installation Procedure
1.
Remove the pedestal and all
accessories form the box.
2.
Make sure that the rear rubber
feet are mounted.
3.
Adjust the front adjustable feet to
make the pedestal stable.
4.
If you install the pedestal under a
brand new appliance, unpack the
appliance as indicated in the
instructions supplied with it and
then proceed with step 6.
5.
If the appliance is already
connected:
- Disconnect the mains plug from
the mains socket.
- For washing machine. Close the
water tap.
- For washing machine.
Disconnect the inlet hose(s) from
the water tap and let the water
flow out from the inlet hose(s)
and the drain hose and collect it
in a shallow basin.
- For tumble dryer. Empty the
water container in a wash basin
or, if available, activate the direct
drain system to let the water flow
out.
6.
Screw the front brackets on the
pedestal.
7.
For washing machine. Gently lay
the washing machine on its
detergent dispenser side.
Lay it on cardboard or on a piece
of polystyrene to avoid scratching
the cabinet.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Kruvige eesmised klambrid
aluse külge.
Asetage pesumasin ettevaatlikult
pesuainejaoturi-poolsele küljele.
Kriimustuste vältimiseks pange
põrandale sobiva suurusega papp või
polüstüreenitükk.
Reguleerige seadme tugijalad
sobivale kõrgusele, et alus saaks
tugijalgade lukustusklambrite all
vabalt liikuda.
Asetage alus samale küljele ja
libistage seda ettepoole nii,
et seadme eesmised tugijalad luku-
stusklambrite all saaksid liikuda.
4
8.
For washing machine. Adjust the
appliance adjustable feet at a
suitable height to allow it to slide
under the foot locking brackets.
9.
For washing machine. Lay the
pedestal on the same side and
slide it forward so that the
appliance front feet slides under
foot locking brackets.
11.
For washing machine. Put the
pedestal and appliance in vertical
position. If necessary, adjust the
appliance feet and go to step 16.
Check that the screws are firmly
screwed.
12.
For tumble dryer. Unscrew and
retain the two bottom screws from
the back of the appliance.
10.
For washing machine. Use the
screws supplied to secure the rear
brackets (B) on both the washer
and the pedestal.
13.
For tumble dryer. Screw the rear
brackets (C) on the pedestal by
using the screws supplied in the
stand box.
Summary of Contents for E6WHPED2
