11.6
Installing the oven door
WARNING!
Be careful when you install
the door. The door is heavy.
1.
Hold the door on the two sides at an
angle of approximately 60°.
3
4
4
60º
5
2.
At the same time push the door
hinges as far as they can go into the
two recesses at the bottom of the
appliance on the left and the right.
3.
Lift the door up until you are at the
point of resistance and then open it as
far as possible.
4.
Fully lock the clamping levers on the
hinges.
5.
Close the door of the appliance.
11.7
Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1.
Deactivate the appliance.
2.
Remove the fuses from the fuse box
or deactivate the circuit breaker.
The side lamp
1.
Remove the left shelf support to get
access to the lamp.
2.
Use a Torx 20 screwdriver to remove
the cover.
3.
Remove and clean the metal frame
and the seal.
4.
Replace the lamp with a halogen, 230
V, 40 W, 300 °C heat resistant lamp.
5.
Install the metal frame and the seal.
Tighten the screws.
6.
Install the left shelf support.
12.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1
What to do if...
Problem
Possible cause
Remedy
You cannot activate or op-
erate the oven.
The oven is not connected
to an electrical supply or it
is connected incorrectly.
Check if the oven is correct-
ly connected to the electri-
cal supply (refer to the con-
nection diagram if available).
The appliance does not
heat up.
The appliance is deactiva-
ted.
Activate the appliance.
The appliance does not
heat up.
The clock is not set.
Set the clock.
The appliance does not
heat up.
The necessary settings are
not set.
Make sure that the settings
are correct.
ENGLISH
17
Summary of Contents for EBCGL70CN
Page 1: ...EBCGL70CN EBCGL70SP EN STEAMER USER MANUAL ...
Page 22: ...www electrolux com 22 ...
Page 23: ...ENGLISH 23 ...
