With some programmes turn
over the food after 30
minutes. The display shows
a reminder.
9. USING THE ACCESSORIES
WARNING!
Refer to Safety chapters.
9.1 Core temperature sensor
There are two temperatures to be set:
the oven temperature and the core
temperature.
The core temperature sensor measures
the core temperature of the meat. When
the meat is at the set temperature, the
oven turns off.
CAUTION!
Only use the core
temperature sensor supplied
or the correct replacement
parts.
The core temperature
sensor must stay in the meat
and in the socket during the
cooking.
1. Put the tip of the core temperature
sensor into the centre of the meat.
2. Put the plug of the core temperature
sensor into the socket at the front of
the oven.
3. Turn on the oven.
The display shows the core temperature
sensor symbol.
4. Press
or
in less than 5
seconds to set the core temperature.
5. Set the heating function and, if
necessary, the oven temperature.
The oven calculates an approximate end
time. The end time is different for the
different quantities of the food, the set
oven temperatures (minimum 120 °C)
and the operating modes. The oven
calculates the end time in approximately
30 minutes.
6. To change the core temperature,
press .
When the meat is at the set core
temperature, a signal sounds. The oven
turns off automatically.
7. Press any symbol to stop the signal.
8. Remove the core temperature sensor
plug from the socket and remove the
meat from the oven.
9. Press to turn off the oven.
WARNING!
The core temperature
sensor is hot. There is a risk
of burns. Be careful when
you remove the tip and the
plug of the core temperature
sensor.
9.2 Using the turnspit
WARNING!
Be careful when you use the
turnspit. The forks and the
spit are sharp. There is a
risk of injury.
WARNING!
Use oven gloves when you
remove the turnspit. The
turnspit and the grill are hot.
There is a risk of burns.
ENGLISH
15
