11
ENGLISH
Language
You can change the language setting if you would like
the indicators in the display to appear in a different
language.
Example:
1. Enter the Menu option and select the Language
setting.
2. Press the «Change» button to select the desired
Language
.
Clock
The clock setting permits you to modify/set up the
current time. It is important to keep it updated as the
current END Cycle Time depends on it
.
Example:
1. Enter the Menu option and select the Clock setting.
2. With a short/single time press of the «Change»
button, the time varies minute by minute. With a
continue pressure of the «Change» button, the
time varies 10 minutes by 10 minutes.
Contrast
The Contrast setting allows you to modify the optical
characteristic of the display.
Example:
1. Enter the Menu option and select the Contrast
setting.
2. Use the «Change» button to set up the desired
contrast level.
Change
Options
Exit
Einstellungen
B
Temp.
Spin
Change
Options
Exit
Sprache
DEUTCH
A
Temp.
Spin
Change
Options
Exit
Language
ENGLISH
Temp.
Spin
Brightness
The Brightness setting allows you to modify the
backlight intensity of the display.
Example:
1. Enter the Menu option and select the Brightness
setting.
2. Use the «Change» button to set up the desired
brightness level
.
Note:
At the end of the programme if no button is pressed
for approximately 10 minutes the backlight intensity
goes off.
6 Vocal messages
An electronic vocal board helps you through all
the dry process, with its clear, simple and helpful
messages.
To activate the vocal messages, press
simultaneously the buttons «
Change
» and «
Exit
».
On the display is written “Voice enable”. If you wish
to disactivated the vocal board, press the same
buttons again. On the display is written “Voice
disable”.
It is possible the select three different levels of
volume (MIN, MED and MAX), by pressing the
«Change» button, entering in MENU and then on
setup option. When the appliance is switched on, a
frielndly jingle can be heard.
There are two kind of messages:
•
messages explaining how to set a drying
programme up and describing the different
options.
Change
Options
Exit
Brightness
B
Temp.
Spin
Change
Options
Exit
Brightness
A
Temp.
Spin
Change
Options
Exit
Contrast
B
Temp.
Spin
Change
Options
Exit
Contrast
A
Temp.
Spin
125981580 gb.qxp 2005-09-21 07:07 Page 11
