Electrolux EDV5552, User Manual

8       www.electrolux.com

Press door 

safety switch 

button.

For drying delicates and 

synthetics at lower heat for 

maximum care of the fabrics. The 

Low Heat setting will cause the 

heater to cycle on for shorter time 

than the Boost setting.
This setting does not heat. ONLY 

circulate the air in the dryer to 

shake out dust and refresh 

clothes.

To obtain the best drying results with 

small loads it is recommended to use 

“Time drying” program.

Press “     ” button or “     ” button 

to select either “Extra Dry”, 

“Normal Dry”, “Iron Dry” for full 

load and  “Fast 40”, “Delicate”, 

“Refresh” for smaller load.

Press the “Option” button to select either 

Boost

 or 

Low Heat

 from the option 

program.

“Airing”

 is NOT available in Drying program.

Press then release the On/Off button on the control 

panel. You are now ready to select your drying 

Program.

This mode gives you the 

option of selecting different 

drying levels.

This option allows you to set 

the program duration.

Do not load clothes or other articles which 

are dripping wet or have sand and grit on 

them into your dryer.

Auto sensing

Manual timing program

You can use your dryer 2 ways

1. Select Drying Program or Set Drying Time

2. Select Option

3. Now press Start/Pause button to start the 

    Dryer.

Step 1

Step 2

Step 3

Do not select the “Extra Dry” option for 

delicates fabric such polyester as 

shrinking may occur.

Press the “     ” button or 

“     ” button to select either 

90, 60 and 30 min.

Refer to the table below for option setting 

recommendations.

See program table guides for load size info.

Boost

Low Heat

Airing

3.2 Operating Sequence

Drying Program

Time drying

Option