Alarm Codes
Current production specific
This range includes the following PBs and PB firmware releases:
-
PB100 after P100R230 (including P100R230)
-
PB101
-
PB150
•
iB0 (iH0)
code: turbidity sensor unknown calibration error
•
The alarm is set if an unknown calibration error has occurred – the
cause of the error is not covered by iB2, iB3 and iB4.
•
The washing program will run as though the dirt value to be
considered is high.
•
iB1 (iH1)
code: turbidity sensor error
•
The alarm is set if lose contact with the turbidity sensor, could be
because the connection to the sensor is lost.
•
The washing program will run as though the dirt value to be
considered is high.
•
iB2 (iH2)
code: turbidity sensor not enough power
calibration error
•
The alarm is set if there is not enough power to drive it to its
intended output value, could be because the sensor is too dirty.
•
The washing program will run as though the dirt value to be
considered is high.
•
iB3 (iH3)
code: turbidity sensor out of range calibration
error
•
The alarm is set if we get invalid sensor reading during the
calibration, could be because the sensor is broken.
•
The washing program will run as though the dirt value to be
considered is high.
•
iB4 (iH4)
code: turbidity sensor too noisy calibration error
•
The alarm is set if the turbidity readings are too noisy during
calibration, could be because of dirt or air bubbles disturbing the
turbidity sensor during calibration.
•
The washing program will run as though the dirt value to be
considered is high.
•
iC0 Code - family : Communication Problem
•
iC0
code: user interface communication
•
The error signal is displayed if the communication system does not
recognize any display board.
•
iC1
code: MACS bus communication
•
After three attempts to establish communication, an error is signalled in the
hardware control
•
iC2
Code: ADSI communication
•
The washing programme is suspended but it can be restarted if the alarm
conditions no longer apply
•
iC3
Code: Communication between boards
•
The alarm is signaled if the communication between the power board and
the motor control board does not start.
•
Acoustic signal and visual alarm, depending on the appliance
customization; the washing program is restarted automatically if the error
conditions no longer apply.
Technical Support – A.R.
Chapter
4
599 79 76 - 53 REV 1.0
