Electrolux EEA22100L, User Manual

3. Press Previous or Next to change

the value.

4. Press OK to confirm the setting.

• The new setting is saved.

• The appliance returns to the

setting selection.

5. Press and hold simultaneously

 and 

 for about 3

seconds to exit setting mode.

The appliance returns to the programme

selection.

The saved settings remain valid until you

change them again.

7. BEFORE FIRST USE

1. Make sure that the current level of

the water softener agrees with the

hardness of the water supply. If

not, adjust the level of the water

softener.

2. Fill the salt container.

3. Fill the rinse aid dispenser.

4. Open the water tap.

5. Start the programme 30min to

remove any residuals from the

manufacturing process. Do not use

detergent and do not put dishes in

the baskets.

After starting the programme, the

appliance recharges the resin in the

water softener for up to 5 minutes. The

washing phase starts only after this

procedure is complete. The procedure is

repeated periodically.

7.1 The salt container

CAUTION!

Use rough salt designed for

dishwashers only. Fine salt

increases the risk of

corrosion.

The salt is used to recharge the resin in

the water softener and to assure good

washing results in daily use.

How to fill the salt container

1. Turn the cap of the salt container

counterclockwise and remove it.

2. Put 1 litre of water in the salt

container (only for the first time).

3. Fill the salt container with 1 kg of salt

(until it is full).

4. Carefully shake the funnel by its

handle to get the last granules inside.

5. Remove the salt around the opening

of the salt container.

6. Turn the cap of the salt container

clockwise to close the salt container.

CAUTION!

Water and salt can come out

of the salt container when

you fill it. After you fill the

salt container, immediately

start a programme to

prevent corrosion.

ENGLISH

13