Electrolux EFC 1540, Instruction Manual

6

GB

11

12a

320

X

116

1÷2

116

650 min.

7.2.1

INSTALLATION

Wall drilling and bracket fixing

Wall marking:
• Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of

the area in which the hood will be installed.

• Draw a horizontal line at 650 mm above the hob.
• Place bracket 

7.2.1

 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the

centre (notch) with the vertical reference line.

• Mark the wall at the centres of the holes in the bracket.
• Place bracket 

7.2.1

 on the wall as shown at X mm below the first bracket (X = height of the upper

chimney section supplied), aligning the centre (notch) with the vertical line.

• Mark the wall at the centres of the holes in the bracket.
• Mark a reference point as indicated at 116 mm from the vertical reference line and 320 mm above

the horizontal reference line.

• Repeat this operation on the other side.
• Drill ø 8 mm holes at all the centre points marked.
• Insert the wall plugs 

11

 in the holes.

• Fix the lower bracket 

7.2.1

  using the 

12a

 screws (4,2 x 44,4) supplied.

• Fix the upper bracket 

7.2.1

 and the air outlet connection support 

7.3

 together using the 2 screws

12a

 (4,2 x 44,4) supplied.

• Insert the two screws 

12a

 (4,2 x 44,4) supplied in the hood body fixing holes, leaving a gap of 5-6

mm between the wall and the head of the screw.