16
electrolux
installation instructions
Installation Instructions
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and
standards in force in the country of use
are to be followed (safety regulations,
proper recycling in accordance with the
regulations, etc.)
Installation may only be carried out by a
qualified electrician.
The minimum distances to other appli-
ances and units are to be observed.
Anti-shock protection must be provided
by the installation, for example drawers
may only be installed with a protective
floor directly underneath the appliance.
The cut surfaces of the worktop are to
be protected against moisture using a
suitable sealant.
The sealant seals the appliance to the
work top with no gap.
Important: If the down draught extractor
is operated at the same time as a gas
appliance, there must be sufficient
draught in the room.
Important: If the down draught ex-
tractor is operated at the same time
as a fireplace, the pressure in the
room must be below 4 Pa (4 x 10
-5
bar).
Important: If the mains cable is de-
fective, it must only be replaced by a
qualified electrician or our Custom-
er Care Department in order to pre-
vent hazards.
z
Risk of injury from electrical
current.
•
The electrical mains terminal is live.
•
Make electrical mains terminal free of
voltage.
•
Follow connection schematic.
•
Observe electrical safety rules.
•
Ensure anti-shock protection by in-
stalling correctly.
•
The appliance must be connected to
the electrical supply by a qualified
electrician.
z
Risk of injury from electrical
current.
•
Loose and inappropriate plug and
socket connections can make the
terminal overheat.
•
Have the clamping connections cor-
rectly installed by a qualified electri-
cian.
•
Use strain relief clamp on cable.
A device must be provided in the electri-
cal installation which allows the appli-
ance to be disconnected from the mains
at all poles with a contact opening width
of at least 3 mm.
Suitable isolation devices include line
protecting cut-outs, fuses (screw type
fuses are to be removed from the hold-
er), earth leakage trips and contactors.
Connect down draught extractor to an
air-tight vent hose or vent pipe with a
120 mm diameter and at least 1 m long.
Summary of Contents for EFD18000U
