ENGLISH
7
Before using the heater make sure that it
is on a flat and stable surface. The
heater must be connected to a an
appropriate electrical outlet.
Keep loose clothing or bedding, furniture
and flammable material away from the
wall outlet where the heater plug is fitted
in.
First you need set the mechanic button
“POWER” to ON by pressing the button
on left back side of heater, then you
press ON/OFF switch to start to
operate the unit according to your own
desire.
Note:
The display will be off without
operation for 120 seconds while unit is
working.
Note:
Current time(Hour/Minutes)need to
be set before entering into
MODE(Home/Office/Cabin) by pressing
timer button , then user can start the
current date and time setting according
to below steps:
Note:
If 7seconds no operation, program
will back to initial value and setting is
ineffective. Only when Hour and Minute
have been confirmed can the setting be
effective.
User must remove the insulating paper
which covered on battery before using
remote control, please follow below
instructions:
1. Remove the battery bracket from back
of remote control like picture A.
A
Note:
This heater
equiped with remote
control which user can
operate the unit
according same step of
control panel
After finishing the setting of hour,
program will automatically enter into
minute setting, 30 and will flash,
user can set minute by pressing
and , digit on display will show from
01, 02,03….to 59. When finish the
setting, press timer setting button to
finish all the setting to enter normal mode
and then you can operate the unit as
normal (display will keep blinking for 7s if
no operation).
User can set up current hour by pressing
timer button, then 23 and symbol
will blink on display, user can set time by
pressing and , digit on display
4.1.1 Hour setting
4.1.2 Minute setting
4.2 Remote Control
°C
P
: Increase the value of temperature
or timer
: Decrease the value of temperature
or timer
: Program menu:
HOME/OFFICE/CABIN
: Temperature, press this button can
lead you to temperature setting
: Timer, press this button can lead
you to temperature setting
: ON/OFF. To start ot shut down the
unit.
P
°C
will show from 00, 01,02….to 23. When
finish the setting, press timer setting
button to enter minute setting
(display will keep blinking for 7s if no
operation)
