Electrolux EGD6576, User Manual

Problem

Possible cause

Remedy

Activate the hob again and

set the heat setting in less

than 10 seconds.

You touched 2 or more

sensor fields at the same

time.

Touch only one sensor

field.

STOP+GO function oper‐

ates.

Refer to "Daily use" chap‐

ter.

There is water or fat stains

on the control panel.

Clean the control panel.

An acoustic signal sounds

and the hob deactivates.

An acoustic signal sounds

when the hob is deactiva‐

ted.

You put something on one

or more sensor fields.

Remove the object from

the sensor fields.

The hob deactivates.

You put something on the
sensor field  .

Remove the object from

the sensor field.

Residual heat indicator

does not come on.

 The zone is not hot be‐

cause it operated only for a

short time.

If the zone operated suffi‐

ciently long to be hot,

speak to an Authorised

Service Centre.

Automatic Heat Up func‐

tion does not operate.

The zone is hot.

Let the zone become suffi‐

ciently cool.

The highest heat setting is

set.

The highest heat setting

has the same power as the

function.

The heat setting changes

between two levels.

Power management func‐

tion operates.

Refer to "Daily use" chap‐

ter.

The sensor fields become

hot.

The cookware is too large

or you put it too near to the

controls.

Put large cookware on the

rear zones if possible.

 comes on.

Automatic Switch Off oper‐

ates.

Deactivate the hob and ac‐

tivate it again.

 comes on.

The Child Safety Device or

the Lock function operates.

Refer to "Daily use" chap‐

ter.

 comes on.

There is no cookware on

the zone.

Put cookware on the zone.

The cookware is incorrect. Use the correct cookware.

Refer to “Hints and tips”

chapter.

www.electrolux.com

16