Electrolux EHG 7815, Instruction Booklet

8

 electrolux

Hob burners control knobs

Hob burners control knobs

Hob burners control knobs

Hob burners control knobs

Hob burners control knobs

 The symbols on the knobs mean that :

 there is no gas supply

 there is maximum gas supply

 there is minimum gas supply

Lighting the burners

Lighting the burners

Lighting the burners

Lighting the burners

Lighting the burners

For easier lighting, proceed before

For easier lighting, proceed before

For easier lighting, proceed before

For easier lighting, proceed before

For easier lighting, proceed before
putting a pan on the pan support.

putting a pan on the pan support.

putting a pan on the pan support.

putting a pan on the pan support.

putting a pan on the pan support.

To light a burner:
push in the relevant control knob and turn
it anticlockwise to maximum position (

),

to ignite the burner.
Upon ignition, keep the knob pushed
down about 5 seconds

 5 seconds

 5 seconds

 5 seconds

 5 seconds. This will allow

the "thermocouple" (Fig. 1 - letter D) to be

heated and the safety device to be
switched off, otherwise  the gas supply
would be interrupted.
Then adjust the flame as required.
To put the flame out, turn the knob to the
symbol

 “ 

 ”

.

If you cannot light the flame even after several attempts, check the "cap"
(Fig.1- lett. A

A

A

A

A) and the"crown" (Fig.1- lett. B

B

B

B

B) are in the correct position.

Do not keep the control knob pressed for more than 15

Do not keep the control knob pressed for more than 15

Do not keep the control knob pressed for more than 15

Do not keep the control knob pressed for more than 15

Do not keep the control knob pressed for more than 15
seconds. If the burner does not light even after 15 seconds,

seconds. If the burner does not light even after 15 seconds,

seconds. If the burner does not light even after 15 seconds,

seconds. If the burner does not light even after 15 seconds,

seconds. If the burner does not light even after 15 seconds,

release the control knob,  turn it the “off” position and wait for

release the control knob,  turn it the “off” position and wait for

release the control knob,  turn it the “off” position and wait for

release the control knob,  turn it the “off” position and wait for

release the control knob,  turn it the “off” position and wait for
at least one minute before trying to light the burner again.

at least one minute before trying to light the burner again.

at least one minute before trying to light the burner again.

at least one minute before trying to light the burner again.

at least one minute before trying to light the burner again.
If the burner does not ignite, turn the control knob to zero, and try
again.
When switching on the mains, after installation or a power cut, it is
quite normal for the spark generator to be activated automatically.
In the absence of electricity, ignition can occur without the electrical
device; in this case, approach the burner with a flame, push the

Operation

Fig. 1

A

 - Burner cap

B

 - Burner crown

C

 - Ignition electrode

D

 - Thermocouple

Triple Crown Burner

A

B

C

D