Electrolux EHH6540F9K, User Manual

3.4 

OptiHeat Control (3 step

Residual heat indicator)

WARNING!

 /   /   There is a risk of

burns from residual heat. The

indicator shows the level of the

residual heat.

The induction cooking zones make the

heat necessary for cooking process

directly in the bottom of the cookware.

The glass ceramic is heated by the heat of

the cookware.

4. 

DAILY USE

WARNING!

Refer to Safety chapters.

4.1 

Activating and deactivating

Touch   for 1 second to activate or

deactivate the hob.

4.2 

Automatic Switch Off

The function deactivates the hob

automatically if:

• All cooking zones are deactivated.

• You do not set the heat setting after

you activate the hob.

• You spill something or put something

on the control panel for more than 10

seconds (a pan, a cloth, etc.). An

acoustic signal sounds and the hob

deactivates. Remove the object or

clean the control panel.

• The hob gets too hot (e.g. when, a

saucepan boils dry). Let the cooking

zone cool down before you use the

hob again.

• You use incorrect cookware. The

symbol   comes on and the cooking

zone deactivates automatically after 2

minutes.

• You do not deactivate a cooking zone

or change the heat setting. After some
time   comes on and the hob

deactivates. See below.

The relation between heat setting and

times of the function:

•

, 

1

 — 

3

 — 6 hours

•

4

 — 

7

 — 5 hours

•

8

 — 

9

 — 4 hours

•

10

 — 

14

 — 1.5 hours

4.3 

The heat setting

To set or change the heat setting:
Touch the control bar at the correct heat

setting or move your finger along the

control bar until you reach the correct heat

setting.

4.4 

Automatic Heat Up

If you activate this function you can get a

necessary heat setting in a shorter time.

The function sets the highest heat setting

for some time and then decreases to the

correct heat setting.

To activate the function the

cooking zone must be cold.

To activate the function for a cooking
zone:

 touch   (  comes on).

Immediately touch the correct heat
setting. After 3 seconds   comes on.

To deactivate the function:

 change the

heat setting.

4.5 

Power function

This function makes more power available

to the induction cooking zones. The

function can be activated for the induction

cooking zone only for a limited period of

time. After this time the induction cooking

zone automatically sets back to the

highest heat setting.

www.electrolux.com

8