Electrolux EHL6540FOK, User Manual

an acute angle and move the blade
on the surface .

–

Remove after the appliance is
sufficiently cool:

 limescale rings ,

water rings, fat stains, shiny metal-
lic discolorations. Use a special

cleaning agent for glass ceramic or
stainless steel.

2.

Clean the appliance with a moist cloth
and some detergent.

3.

At the end 

rub the appliance dry

with a clean cloth.

6. 

TROUBLESHOOTING

Problem

Possible

Remedy

You cannot activate the
appliance or operate it.

Activate the appliance
again and set the heat
setting in less than 10
seconds. 

You touched 2 or more
sensor fields at the same
time.

Touch only one sensor
field.  

The Stop+Go function
operates.

Refer to the chapter “Dai-
ly use”.

There is water or fat
stains on the control pan-
el.

Clean the control panel.

An acoustic signal
sounds and the appliance
deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.

You put something on
one or more sensor fields.

Remove the object from
the sensor fields.

The appliance deacti-
vates.

You put something on the
sensor field 

 .

Remove the object from
the sensor field.

The residual heat indica-
tor does not come on.

The cooking zone is not
hot because it operated
only for a short time.

If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.

The Automatic Heat Up
function does not oper-
ate.

The cooking zone is hot.

Let the cooking zone be-
come sufficiently cool.

The highest heat setting
is set.

The highest heat setting
has the same power as
the Automatic Heat Up
function.

The heat setting changes
between two levels.

The Power management
is activated.

Refer to “Power manage-
ment”.

The sensor fields become
hot.

The cookware is too large
or you put it too near to
the controls.

Put large cookware on
the rear cooking zones if
necessary.

12 www.electrolux.com