Electrolux EHL6740FAZ, User Manual

Problem

Possible cause

Remedy

Residual heat indicator

does not come on.

 The zone is not hot be‐

cause it operated only for a

short time.

If the zone operated suffi‐

ciently long to be hot,

speak to an Authorised

Service Centre.

Automatic Heat Up func‐

tion does not operate.

The zone is hot.

Let the zone become suffi‐

ciently cool.

The highest heat setting is

set.

The highest heat setting

has the same power as the

function.

The heat setting changes

between two levels.

Power management func‐

tion operates.

Refer to "Daily use" chap‐

ter.

The sensor fields become

hot.

The cookware is too large

or you put it too near to the

controls.

Put large cookware on the

rear zones if possible.

There is no signal when

you touch the panel sensor

fields.

The signals are deactiva‐

ted.

Activate the signals.

Refer to "Daily use" chap‐

ter.

 comes on.

Automatic Switch Off oper‐

ates.

Deactivate the hob and ac‐

tivate it again.

 comes on.

The Child Safety Device or

the Lock function operates.

Refer to "Daily use" chap‐

ter.

 comes on.

There is no cookware on

the zone.

Put cookware on the zone.

The cookware is incorrect. Use the correct cookware.

Refer to “Hints and tips”

chapter.

The diameter of the bottom

of the cookware is too

small for the zone.

Use cookware with correct

dimensions.

Refer to “Technical infor‐

mation” chapter.

 and a number come on. There is an error in the

hob.

Disconnect the hob from

the electrical supply for

some time. Disconnect the

fuse from the electrical

system of the house. Con‐
nect it again. If   comes

on again, speak to an Au‐

thorised Service Centre.

 comes on.

The electrical connection is

incorrect. The supply volt‐

age is out of range.

Speak to a qualified electri‐

cian to check the installa‐

tion.

ENGLISH

15