Electrolux EHS 60020 K, User Manual

20

 electrolux 

installation instructions

Installation Instructions

Safety instructions

The laws, ordinances, directives and 
standards in force in the country of use 
are to be followed (safety regulations, 
proper recycling in accordance with the 
regulations, etc.)
Installation may only be carried out by a 
qualified electrician.
The minimum distances to other appli-
ances and units are to be observed.
Anti-shock protection must be provided 
by the installation, for example drawers 
may only be installed with a protective 
floor directly underneath the appliance.
The cut surfaces of the worktop are to 
be protected against moisture using a 
suitable sealant.
The sealant seals the appliance to the 
work top with no gap.
The sealant seals the appliance to the 
work top with no gap.
Do not use silicon sealant between the 
appliance and the work top.
Avoid installing the appliance next to 
doors and under windows. Otherwise 
hot cookware may be knocked off the 
rings when doors and windows are 
opened.

WARNING!
Risk of injury from electrical cur-
rent.

•

The electrical mains terminal is live.

•

Observe connection schematic.

•

Observe electrical safety rules.

•

Ensure anti-shock protection 
through correct installation by a 
qualified electrician.

•

The appliance must be connected to 
the electrical supply by a qualified 
electrician.

IMPORTANT!
Risk of injury from electrical cur-
rent.

Loose and inappropriate plug and sock-
et connections can make the terminal 
overheat.

•

Have the clamping joints correctly in-
stalled by a qualified electrician.

•

Use strain relief clamp on cable.

•

In the event of single-phase or two-
phase connection, the appropriate 
mains cable of type H05BB-F Tmax 
90°C (or higher) must be used.

•

If this appliance’s mains cable is 
damaged, it must be replaced by a 
special cable (type H05BB-F Tmax 
90°C; or higher). Please contact your 
local Service Force Center for further 
advice.

A device must be provided in the electri-
cal installation which allows the appli-
ance to be disconnected from the mains 
at all poles with a contact opening width 
of at least 3 mm 
Suitable isolation devices include line 
protecting cut-outs, fuses (screw type 
fuses are to be removed from the hold-
er), earth leakage trips and contactors.