Electrolux EHT7830, User Manual

4. With a thin screwdriver, adjust the by-

pass screw position.

1

1

The by-pass screw

– If you change from natural gas 20

mbar to liquid gas, fully tighten the
by-pass screw in.

– If you change from liquid gas to natu-

ral gas 20 mbar, undo the by-pass
screw approximately 1/4 of a turn
(1/2 of a turn for Triple Crown burn-
er).

Warning!

 Make sure the flame does

not go out when you quickly turn the
knob from the maximum position to the
minimum position.

ELECTRICAL CONNECTION

• The electrical work necessary to install

the appliance must be done by a quali-
fied electrician or competent person, ac-
cording to the current regulations.

•

The appliance must be earthed.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains
plug.

• The appliance must not be connected

with an extension cable, an adapter or a
multiple socket. There is a risk of fire.
Make sure that the ground connection
complies with the standards and regula-
tions force.

• The power cable must not touch any hot

parts.

• The electrical installation must have an

isolation device which lets you discon-
nect the appliance from the mains at all
poles. The isolation device must have a

contact opening width of minimum 3
mm.

• You must have the correct isolation devi-

ces: line protecting cut-outs, fuses
(screw type fuses removed from the
holder), earth leakage trips and contac-
tors.

• The connection cable parts must not be

heated to a temperature above 90°C.

Electrical Requirements

Permanent electrical installation must com-
ply with the latest I.E.E. Regulations and lo-
cal Electricity Board regulations. For your
own safety the installation must be done by
a qualified electrician (e.g. your local Elec-
tricity Board, or a contractor who is on the
roll of the National Inspection Council for
Electrical Installation Contracting [NICEIC]).

The manufacturer declines any liability
if these safety measures are not ob-
served.

The appliance must be connected to a 230
V 50 Hz AC electrical supply.
Before activating the appliance, make sure
the electrical supply voltage is the same as
that indicated on the rating plate. The rating
plate is located on the bottom of the appli-
ance.
The appliance is supplied with a 3 core flex-
ible supply cord with a 3 amp plug. If it is
necessary to change the fuse, use a 3 amp
ASTA-approved (BS 1362) fuse.

6 

electrolux