14
Installing Door Handles
Door Handle Mounting Instructions
End
Cap
End
Cap
End
Cap
End
Cap
Mounting
Refrigerator
Handles
End
Cap
End
Cap
Mounting
Freezer
Handle
CAUTION
Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.
NOTE
An Allen wrench is supplied in the handle packaging. When using the Allen wrench to tighten the
Allen set screws (C), it is imperative that force be applied to the longer arm of the Allen wrench to
ensure that the set screws are completely tightened so that handles are flush with doors/drawer.
1. Remove handles from protective packaging.
2. Position fresh food handle end caps (A) over upper and lower pre-installed shoulder
bolts (B) that are fastened into door, ensuring the holes for the set screws are facing
towards the opposite door.
3. While holding handle firmly against door, fasten upper and lower Allen set screws
(C) with supplied Allen wrench.
4. Repeat steps 2 and 3 to install opposite handle. Ensure the holes for the set screws
are facing towards the first door.
5. Position freezer handle end caps over left and right pre-installed shoulder bolts (B) that
are fastened to the drawer, ensuring the holes for the set screws are facing down.
6. While holding handle firmly against drawer, fasten left and right Allen set screws (C)
with supplied Allen wrench.