8
Installation
Screw
Flipper
Mullion
Hinge
Flipper
Mullion
Adjusting Flipper Mullion Screw
To adjust the flipper mullion:
1 Loosen the screw located on the
flipper mullion hinge.
2 Adjust flipper mullion height. For
proper connection with the flipper
mullion guide, there should be a
separation about the thickness of
a coin (0.060 inches, or 1.5 mm)
between the guide and flipper
mullion.
3 Re-tighten screw.
Flipper
Mullion
Mullion
Guide
Thickness
of a Coin
Adjusting Flipper Mullion Height
Installing Shelves (select models)
Your refrigerator was shipped with the
shelf hanger and glass shelves in a
shipping pack. Below are the instructions
to install and remove the shelves in your
desired locations.
1 Place top hooks of the hanger into
the desired slot, and lower straight
down until lower hooks rest on the
ladder.
2 Relock shelf by pushing the slide
mechanism away from you.
3 While holding shelf at a 45-degree angle
with the gray handle facing you, push
the shelf into the back of the hanger.
CAUTION
Shelves must be removed prior to
moving the refrigerator.