12
Removing the Doors
Once both doors are in place, ensure they are aligned
with each other and level (Please see the
Installation
section for more details), and replace the top hinge cover.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury,
or damage to the doors or handles.
NOTE
You will be pulling approximately five (5) feet of water
tube from the back of the refrigerator.
Lower Hinge Removal
4
Unscrew the three (3) lower hinge screws and
hinge if necessary.
To reinstall the right door, reverse the above steps.
Removing Freezer Drawer
1
Open freezer drawer.
2
Remove drawer screws on right and left sides
(two (2) screws on each side).
3
Lift drawer up and out to remove.
Installing Freezer Drawer
1
With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are
fully inserted into slots on each side.
CAUTION
Drawer is heavy. Use caution when lifting.
6
Tighten four (4) drawer screws.
7
Recheck gasket seal.
8
Install the toe grille by fitting into place.
2
Reinstall four (4) drawer screws (two (2) per
side), tighten down, and close drawer (C).
Pull Drawer Out
From Both Sides
Grab Drawer
At Center
Then
Push Against
Freezer Drawer
A
B
Fully Extend
Assembly
Drawer Slides
Pin
Slot
Cabinet
Drawer
3
Check gasket seal around top, bottom, and sides
of freezer drawer.
4
If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each
side) to allow drawer to rotate.
5
Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
NOTE
When reinserting the water tube and replacing the top
hinge cover, use care to be sure you do not kink the
tube.