6
Installation
Door opening
Your refrigerator should be positioned to allow easy
access to a counter when removing food. For best
use of drawers and freezer baskets, the refrigerator
should be in a position where both the refrigerator
and freezer doors can be fully opened.
Guidelines for final positioning of your
refrigerator:
• All four corners of the cabinet must rest firmly
on the floor.
• The cabinet should be level at the front and
rear.
• The sides should tilt ¼ inch (6 mm) from front
to back (to ensure that doors close and seal
properly).
• Doors should align with each other and be
level.
All of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front rollers
:
1
Open both doors and remove the toe grille
(see “
Toe Grille Installation and Removal
”
in the “
Installation”
section).
2
Close the doors and use a flat-blade
screwdriver or
³⁄₈
inch socket wrench to raise
or lower the front rollers.
3
Ensure both doors are bind-free with their
seals touching the cabinet on all four sides.
NOTE
The refrigerator doors are designed to shut by
themselves within a 20 degree opening.
4
After leveling, verify door stop contacts lower
hinge and top of door does not contact upper
hinge through full movement of door (from
fully closed to fully open).
5
Reinstall set screw, locking the door height.
6
Replace the toe grille by fitting it into place
(see “Toe Grille Installation and Removal” in
the “Installation” section).
NOTE: Level the unit with the adjustable rollers
before leveling the doors.
To level the doors using the adjustable lower
hinge (some models)
:
1
Before leveling either door, remove set screw
that locks door height into position. (The
door cannot be adjusted without set screw
removed).
2
If the refrigerator door is lower than the
freezer door, raise the refrigerator door by
turning the adjustment screw clockwise using
a
7
/
16
inch wrench. (See illustration.)
3
If the freezer door is lower than the
refrigerator door, raise the freezer door by
turning the adjustment screw clockwise using
a
7
/
16
inch wrench. (See illustration.)
Hinge
Flange
Set Screw
(some models)
Door Stop
Flange
Hinge
Open Door
7/16” Wrench
and 3/32” Hex Key
(some models)
Summary of Contents for EI23CS35KB
Page 14: ...14 Controls Wave TouchTM IQ TouchTM ...
Page 44: ......