8
Removing The Doors
Getting through narrow spaces
If your refrigerator will not fit through an entrance area, you can reduce its size by removing the doors.
Check first by measuring the entrance.
Required Tools
You will need the following tools:
Adjustable
Wrench
Socket
Wrench Set
OR
Phillips Head
™
Tools Necessary:
3/8” Fixed
Wrench
AND
OR
To prepare for removing the doors:
1
Make sure the electrical power cord is unplugged from the wall outlet.
2
Open both doors and remove the toe grille (as explained in the
Installation Instructions that came with your appliance).
3
Remove any food from the door shelves.
4
Close the doors.
To remove the refrigerator top hinge cover:
1
Remove the three screws from each cover over the top door hinges.
2
Lift hinge cover straight up and off.
Top Hinge
Cover Rear
Screw
Top Hinge
Cover Front
Screw
Bottom
Hinge
Screw
Top
Hinge
Screw
To remove the refrigerator door:
1
Trace lightly around the door’s top hinge with a pencil. This makes
reinstallation easier.
2
Remove the two screws from the top hinge. Lift the door off of the
bottom hinge and set it aside.
3
Remove the two bottom hinge screws and hinge if necessary.
Adjustable Hinge
(some models)
Non-Adjusting Hinge
(some models)
CAUTION
Be sure doors are
set aside in a secure
position where they
cannot fall and cause
personal injury.
To reinstall the refrigerator door, reverse the above steps.
Summary of Contents for EI23CS35KB
Page 14: ...14 Controls Wave TouchTM IQ TouchTM ...
Page 44: ......