23
Automatic Ice & Water Maker/Dispenser
Priming the water supply
system
1 Begin filling
the system
by pressing
and holding
a drinking
glass against
the water
dispenser
paddle.
2 Keep the
glass in this position until water comes
out of the dispenser. It may take about
1½ minutes.
3 Continue dispensing water for about three
minutes to flush the system and plumbing
connections of any impurities (stopping to
empty the glass as necessary).
Ice maker operation & care
After the refrigerator is installed properly and
has cooled for several hours, the ice maker
can produce ice within 24 hours. The ice
maker will fill the ice bin from the rear. You
must dispense some ice to force the ice
forward in the bin. This will allow the bin to fill
completely.
Ice Maker and Storage
Bin Capacity
This ice maker should produce 2.5 to 3
pounds of ice per 24 hours.
In a Standard Depth model, the ice bin will
hold about 6.5 pounds of ice. In a Counter
depth model, the ice bin will hold about 4
pounds of ice.
Turning the fresh food ice maker
on and off
Ice production is controlled by the ice maker’s
On/Off icon on the control panel. Press and
hold the “Ice Off” icon for three seconds to
turn the ice maker “ON” or “OFF”. If there is
no indicator, then the ice maker is ON.
IMPORTANT
Your ice maker is turned on at the factory
so it can work as soon as you install your
refrigerator. If you cannot connect a water
supply, set the ice maker’s On/Off icon
to Off; otherwise, the ice maker’s fill valve
may make a loud chattering noise when it
attempts to operate without water.
CAUTION
For proper dispenser operation,
recommended water supply pressure
should fall between 30 psi and 100
psi. Excessive pressure may cause the
system to malfunction.
NOTE
The water dispenser has a built-in device that
shuts off the water flow after three minutes of
continuous use. To reset this shutoff device,
simply release the dispenser paddle.
NOTE
The ice maker also has a built-in plastic
signal arm that automatically stops ice
production when the ice bin is full. This
signal arm should not be used to manually
stop the ice maker.
IMPORTANT
Turning off the ice maker simply disables
ice making. You will still be able to dispense
existing ice, and you will still be able to
dispense water.