10
Installation Instructions
Snap one end of the drain hose hanger
1.
(shipped in washer drum) onto the drain hose.
Continue wrapping it around the hanger and
snap it in place.
Place the hook end of the drain hose in the drain
2.
opening. Secure the drain hose with the cable tie
(provided in the enclosure package) to the stand-
pipe, inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the water.
Connecting drain and electrical
Grounding type
Grounding type
wa
wall receptacl
ll receptacle
Po
Power cord with
wer cord with
3-prong
3-prong gr
grounded plug
ounded plug
Do not,
Do not, under
under
an
any cir
y circumstances,
cumstances,
cut,
cut, remo
remove
ve,
or b
or bypass th
ypass the
gr
grounding pr
ounding prong.
ong.
IMPORTANT
Check to ensure the power is off at a circuit
breaker/fuse box before plugging the power cord
into an outlet.
Plug the power cord into a grounded outlet.
3.
Turn on the power at a circuit breaker/fuse box.
4.
Carefully slide the washer to its fi nal position.
5.
Recheck for level and rock corners for stability.
Remove and discard door tape.
Read the
6.
Use & Care Guide
provided with the
washer. It contains valuable and helpful infor-
mation that will save you time and money.
See the next page about performing a brief,
7.
helpful “Installation Cycle” on your new washer.
If you have any questions during initial opera-
8.
tion, please review the “Service Prevention
Checklist” in your
Use & Care Guide
before
calling for service.
Place these instructions in a location near the
9.
washer for future reference.
NOTE
A wiring diagram and technical data sheet are
located under the washer top panel, on top of the
detergent dispenser housing.
CABLE TIE
