electrolux
21
GB
spacer (b) under the door mount is
also removed (Fig. 3).
Lift the freezer door up slightly and
remove.
Remove the plug on the upper side of
the freezer door and put it to the other
side.
Lift out the insert for the lower
covering grid (e) using a screw driver
(Fig. 4).
Unscrew the bottom door retaining pin
for the freezer door (h, f) and then
screw in on the other side. Don't
forget the spacer (h) (Fig. 4).
Insert the insert for the lower covering
grid (e) on the other side.
Remove the left-hand cover pin of the
double door mount (3 pieces, n, k)
and move to the other side (Fig. 3).
Fig. 4.
Fit the pin of the double door mount
(m) into the left-hand hole of the
freezer door (Fig. 3).
Place the freezer door on the lower
door retaining pin (f) (Fig. 4).
Open doors and fix the double door
mount with 2 screws (c) on the left-
hand side. Don't forget the plastic
spacer under the door (b) as well. The
edges of the doors must run parallel to
the side edge of the appliance.
Place the fridge door on the double
door retaining pin.
Remove the top left-hand side door
mount (f) and the panel (c) from the
plastic bag and attach using the
screws (c) (Fig. 1).
Open the fridge door, attach the top
cover (j) using 2 screws (a); at the
same time pay attention to the
repositioning of the magnet (k), then
close the door (Fig. 2).
Put the appliance into position, make
adjustments if not horizontal and
connect to the electrical supply.
If you do not want to carry out these steps
yourself, please contact the nearest
branded service point. Technicians will
make a charge for door reversal.
