Electrolux EOB33100, User Manual

Installing the shelf support rails

Install the shelf support rails in opposite se-
quence.

The rounded ends of the shelf support
rails must point to the front!

Oven lamp

Warning!

 There is a danger of

electrical shock!

Before you change the oven lamp:

• Switch off the oven.
• Remove the fuses in the fuse box or

switch off the circuit breaker.

Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.

Replacing the oven lamp
1. You can find the lamp glass cover at the

back of the cavity.
Turn the lamp glass cover counterclock-
wise to remove it.

2. Clean the glass cover.
3. Replace the oven lamp with applicable

300°C heat-resistant oven lamp.

Important!

 Use the same oven lamp type.

4. Install the glass cover.

Oven Ceiling

You can fold down the heating element on
the oven ceiling to clean the oven ceiling
easily.

Warning!

 Before you fold down the

heating element switch off the
appliance. Make sure that the
appliance is cold.
There is a risk of burns!

Folding down the heating element
1. Remove the shelf support rails.
2. Hold the heating element with the two

hands at the front

3. Pull it forwards against the spring pres-

sure and out along the support on both
sides.

4. The heating element folds down.

The oven ceiling is ready to clean.

Installing the heating element
1. Install the heating element in opposite se-

quence.

Important!

 Install the heating element

correctly on the two sides above the
support on the inner wall of the oven.
2. Insert shelf support rails.

Oven door and glass panels

To clean the oven door remove it.

Caution!

 Be careful when you remove

the door from the appliance. The door
is heavy!

Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two

door hinges fully.

A

A

3. Close the oven door until the first posi-

tion (angle approx. 45°).

16 

 electrolux