Electrolux EPEH, Instruction Booklet

12

30

20 min

60

a

b

FO 1013

3

Dimensions are given in mm.

Building over a kitchen unit

with door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the bottom

of the hob which can be hot when in operation. The

recommended solution is shown in diagram 3.

The panel fitted under the hob  ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

FO 0199

a

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

• put the seals supplied with the hob, on the

edges of the cut out: place them exactly on

the front and rear edge and at 50 mm. from the

side edges, taking care that the seals meet

without overlapping;

• place the hob in the cut out, taking care that it

is centred;

• fix the hob with the relevant fixing clamps and

screws, as shown in the diagram. When the

screws have been tightened, the excess seal

can be removed.

The edge of the hob forms a double seal which prevents

the ingress of liquids.

Seal

F