15
ENGLISH
Problem
Possible Causes
Solution
Incompressible gas or
moisture has entered the
system.
Evacuate and recharge the
system with refrigerant
The compressor is broken Replace the compressor
The voltage is too high or
too low
Install a manostat to regulate the
voltage
Poor heating
performance
The outdoor temperature
is exetremtly low
Use auxiliary heating devic
Cold air is entering
through doors and
windows
Make sure that all doors and
windows are closed during use
Low refrigerant due to
leak or long-term use
Check for leaks, re-seal if
necessary and top off refrigerant
Indicator lamps
continue flashing
The unit may stop operation or continue to run safely. If the
indicator lamps continue to flash or error codes appear, wait
for about 10 minutes. The problem may resolve itself.
If not, disconnect the power, then connect it again. Turn the
unit on.
If the problem persists, disconnect the power and contact your
nearest customer service center.
Error code appears
in the window
display of indoor
unit:
•
E0, E1, E2…
•
P1, P2, P3…
•
F1, F2, F3…
NOTE:
If your problem persists after performing the checks and diagnostics above,
turn off your unit immediately and contact an authorized service center.
Summary of Contents for EPS09V57HW
