CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person move
or lift the appliance.
If washer or dryer is new and has not been installed yet, skip
1.
to step 4.
If dryer is already installed, disconnect dryer from electrical
2.
and gas connections and exhaust venting. On models with
Steam Option, turn off cold water supply and disconnect wa-
ter supply hose to dryer.
If washer is already installed, disconnect washer from electri-
3.
cal connection. Turn off hot and cold water supply and dis-
connect hot and cold water supply hoses from water supply
outlets. Disconnect drain hose from drain pipe.
Protect fl oor and unit with cardboard or rug and carefully lay
4.
the appliance on its side and screw each leg completely into
the base.
NOTE
Allow for approximately 5 in. (12.5 cm) behind the pedestal
for clearance of back of washer or dryer to the wall. Allow an
additional 3/4 in. (2 cm) for water inlet on Steam Model Dryers
and additional space if venting dryer upward or downward.
NOTE
Due to higher center of gravity of appliance on pedestals, some
side-to-side rocking is normal during operation. Vibration can be
minimized by assuring appliance is installed properly, including being
level and solid on all four (4) legs by following these directions.
lock nut
2
Prepare appliance for mounting
Prepare pedestal before mounting
Locate pedestal
1.
to within a few
inches of its
fi nal location.
Level the pedestal
2.
front-to-back and
side-to-side by ad-
justing each leveling
leg. Keep leg exten-
sion to a minimum.
Rock the pedestal from corner-to-corner to check for stability.
3.
Repeat leveling and rocking until all four (4) feet are sturdy on
the fl oor and pedestal is level.
Without turning the rubber foot, lock each pedestal leg in
4.
place by tightening its lock nut tight against the pedestal
base.
DO NOT remove foam!
raise
lower
adjustable
pliers
IMPORTANT
DO NOT use open dispenser drawer of washer or dispenser
cavity as hand-hold location when tipping washer on its side.
Serious damage could occur to your washer.
IMPORTANT
If feet are not completely screwed in, mounting holes in
appliance will not align to mounting holes in brackets.
Summary of Contents for EPWD15T
Page 11: ......
