4 mounting optional side burner
electrolux en:v barbecue
5. Assemble screws to side of trim panel loosely, allowing
clearance for the side burner trim panel to fit under
head of screw.
6. Slide side burner against main barbecue trim with
notches behind screw heads and then lower into position
7. Tighten screws to clamp side burner to main barbecue.
You may need to remove the control knob for screw
driver access.
8. Insert and tighten 4 screws securing brackets to corner
posts. Tighten screws previously fitted to bracket.
1. Release support rod ends from slots.
2. Remove side table mounting screws, and remove side
table. Re-fit screws without side table.
3. Remove lid, trivet and burner crown from side burner.
4. Fit brackets to side burner, do not tighten screws but
allow some movement for fitting.
Mounting optional side burner
Release rod from
slot by pushing
ends of rod toward
centre as shown
remove
mounting
screws
screws fit loosely
to allow side burner
to fit behind screw
head before tightening
notches to be placed over loose screw heads
top of bracket just
fits under trim before
lowering into position
slide side burner notches
over screw heads
and lower into position
Tighten screw using phillips head screwdriver.
Place screwdriver through holes to engage screws
Insert screws and
tighten each side
Insert screws and
tighten each side
