4.5 Bridge function
The function operates when
the pot covers the centres of
the two zones.
This function connects two left side
cooking zones and they operate as one.
First set the heat setting for one of the
left side cooking zones.
To activate the function: touch . To
set or change the heat setting touch one
of the control sensors.
To deactivate the function: touch .
The cooking zones operate
independently.
4.6 Automatic Heat Up
Activate this function to get a desired
heat setting in a shorter time. When it is
on, the zone operates on the highest
setting in the beginning and then
continues to cook at the desired heating
setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch ( comes on).
Immediately touch a desired heat setting.
After 3 seconds comes on.
To deactivate the function: change the
heat setting.
4.7 Power function
This function makes more power
available to the induction cooking zones.
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
Refer to “Technical
information” chapter.
To activate the function for a cooking
zone: touch . comes on.
To deactivate the function: change the
heat setting.
4.8 Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
First set the cooking zone then set the
function.The selection of the Timer
function is possible for cooking zones
that are active and after the heat setting
is set.
To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on.
When this function is active, comes
on.
To activate the function: touch of
the timer to set the time (00 - 99
minutes). When the indicator of the
cooking zone starts to flash slowly the
time counts down.
To see the remaining time: set the
cooking zone with . The indicator of
the cooking zone starts to flash quickly.
The display shows the remaining time.
To change the time: set the cooking
zone with . Touch or .
To deactivate the function: set the
cooking zone with and touch . The
remaining time counts back to 00. The
indicator of the cooking zone goes out.
When the time comes to an
end, the sound operates and
00 flashes. The cooking
zone deactivates.
To stop the sound: touch .
CountUp Timer (The count up
timer)
You can use this function to monitor how
long the cooking zone operates.
To set the cooking zone (if more than
1 cooking zone operates): touch
again and again until the indicator of a
necessary cooking zone comes on.
When this function is active, comes
on.
www.electrolux.com
10
Summary of Contents for EQL4520BOZ
Page 67: ...DEUTSCH 67 ...
