12
INSTALLATION
If this appliance featuring magnetic door seals is to re-
place an older appliance having a spring lock (latch),
be sure to make that spring lock unusable before you
discard the old appliance. This will prevent it from be-
coming a death-trap for a child.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct sun-
light etc.
Best performance is obtained with ambient tempera-
ture b18
°
C and +43
°
C (class T); +18
°
C and
+38
°
C (class ST); +16
°
C and +32
°
C (class N); +10
°
C
and +32
°
C (class SN).
The class of your appliance is shown on its rating
plate.
For building-in instructions, see the relevant section.
Electrical connection
Before you plug the appliance into a mains supply,
make sure that the voltage and frequency shown on
the rating plate correspond to your home supply.
A 6% fluctuation above or below the rated voltage is
admissible.
To adapt the appliance to other voltages, use a suita-
ble autotransformer.
It is essential that the appliance be connected to
an efficient earth tap.
For this purpose the supply cable plug incorporates a
special earth contact.
If the sockets of your domestic wiring system are not
grounded, have the appliance connected to a sepa-
rate ground wire by a qualified electrician in accord-
ance with the existing safety regulations.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio inter-
ference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modifications.
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly. Do
not use detergents which will leave an odour or abra-
sive powders on the interior, as these will damage the
finish.
Building-in instructions
Fig. 1
D112
P
P1
A
P
P1
Door reversibility
(Fig. 1)
Right opening
Remove the pins (P) and (P1).
Left opening
Remove (P) from both sides and the door. Remove (A)
and refit it on the opposite side. Refit the door and (P)
on the left side. Remove (P1) from the right side.
