Electrolux ERI635DSE, Manual

3

ENGLISH

1.  SAFETY INFORMATION

For your safety and correct operation of the appliance, 
read this manual carefully before installation and use. 

Always keep these instructions with the appliance even if 
you move or sell it. Users must fully know the operation 
and safety features of the appliance.

The wire connection has to be done by specialized 

technician.

• The manufacturer will not be held liable for any damages 

resulting from incorrect or improper installation.

• The minimum safety distance between the cooker top and 

the extractor hood is 650 mm (some models can be installed 
at a lower height, please refer to the paragraphs on working 
dimensions and installation).

• If the instructions for installation for the gas hob specify a 

greater distance, this must be respected. 

• Check that the mains voltage corresponds to that indicated 

on the rating plate fixed to the inside of the hood.

• 

Means for disconnection must be incorporated in the fixed 

wiring in accordance with the wiring rules.

• For Class I appliances, check that the domestic power sup-

ply guarantees adequate earthing.

• 

Connect the extractor to the exhaust flue through a pipe of 

minimum diameter 120 mm. The route of the flue must be 

as short as possible.

• Regulations concerning the discharge of air have to be 

fulfilled.

• Do not connect the extractor hood to exhaust ducts carrying 

combustion fumes (boilers, fireplaces, etc.).

• If the extractor is used in conjunction with non-electrical ap-

pliances (e.g. gas burning appliances), a sufficient degree of 

aeration must be guaranteed in the room in order to prevent 

the backflow of exhaust gas. When the cooker hood is used 

in conjunction with appliances supplied with energy other 
than electric, the negative pressure in the room must not 
exceed 0,04 mbar to prevent fumes being drawn back into 
the room by the cooker hood.

• 

The air must not be discharged into a flue that is used for